Conductivity inductive - TriOS Mess- und Datentechnik

Go to content
Conductivity Inductive

Optical sensor for inductive conductivity.
The inductive conductivity sensor has 2 toroidal coils which are housed in a plastic casing and therefore do not come into contact with the surrounding solution. For this reason, it is physically impossible for the sensor surface to become soiled, coated or contaminated.

Since the inductive conductivity sensor does not determine the conductivity via electrodes, but via electrical fields, no polarization effects occur. Thus the sensor provides more accurate measurement results, especially for measurement media with high conductivities.

The sensor housing is made of Noryl, which is extremely resistant to chemicals.
Measurement ­technology
Change of inductance
Measurement principle
Change of inductance with two toroidal coils


Parameter
Conductivity
Measurement range
0.5 mS⁄cm – 2000 mS⁄cm
Measurement accuracy
± (2% + 20 μS/cm)
Drift
0.1 % / Year
Turbidity compensation
No
Temperature compensation
Via NTC
Data Logger
No
Response time
T90, depending on equilibrium
Measurement interval
10 seconds


Housing material
Noryl
Dimensions (L x Ø)
119 mm x 52 mm

Weight
0.1 kg



Interface
RS-485 Modbus RTU (Baud rate = 9600)
Power consumption
< 75 mW
Power supply
7‒40 VDC
Connection
8-pin M12 connector
Maintenance effort
≤ 0.5 h/month typical
Maintenance interval
24 Months
Calibration method
Two-point calibration in air and with standard measuring solution during
initial installation, followed by validation
System compatibility
Modbus RTU
Warranty
1 year, EU & USA: 2 years


Max. pressure
10 bar

Protection type
IP68
Sample Temperature
-10 °C ... +70 °C (max. 85 °C)

Ambient Temperature
-10 °C ... +70 °C (max. 85 °C)

Storage Temperature
-20 °C ... +80 °C

Inflow velocity
Max. 3 m/s, Steady and constant flow




Back to content